08-24-2004 10:34 PM - edited 03-09-2019 08:35 AM
Hi,
We have a set up a site-to-site VPN connection between two Cisco 3745 routers running 12.3.6. The tunnel is working fine, but sometimes the CPU utilization on both routers go up to almost 100% and I can see that it is the Encryption Process that is using the processor. When I do a "debug cry engine" I get the following error:
CRYPTO_ENGINE: crypto_pak_coalesce: could not allocate pak
I tried to search for the error message, but could not find any results. Has anyone seen this messages and got a clue of what could be wrong?
Any help would be appreciated!
Regards,
Harald
08-30-2004 11:41 AM
All the important IPSec debug commands with their oututs are exlained in this document,
08-30-2004 10:57 PM
Thank you very much for the information, but unfortunately my error message is not included in the document. The IPsec connection works fine for me, it is only that the CPU utilization is very high.
Regards,
Harald
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: