cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
508
Views
0
Helpful
1
Replies
Highlighted
Beginner

Debugging and telnet

I've used telnet to access my Pix. When I issue the debug command, no debugging info is displayed. Why is this?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Debugging and telnet

Did you do "term mon", plus "logging console debug" and/or "logging monitor debug"? Do you have a terminal plugged into the console, cause some PIX debugs (debug packet for example) will automatically be sent there regardless of where you entered the command.

View solution in original post

1 REPLY 1
Cisco Employee

Re: Debugging and telnet

Did you do "term mon", plus "logging console debug" and/or "logging monitor debug"? Do you have a terminal plugged into the console, cause some PIX debugs (debug packet for example) will automatically be sent there regardless of where you entered the command.

View solution in original post