DHCP SERVER on IOS XR Cisco ASR9001

[sergei-bilan]

Hello. Can I configure the IOS XR ASR9001 as a DHCP server? It is necessary that he would distribute IP addresses in the VRF.

[Jaderson Pessoa]

Yes, you can do it.

check it for how to procedure: https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k_r5-1/addr_serv/configuration/guide/b_ipaddr_cg51xa9k/b_ipaddr_cg51xa9k_chapter_0101.html

[sergei-bilan]

Thanks for the documentation. How to write a post, re-read a lot of documentation. Everywhere I found that in IOS XR you can configure for ipv4 DHCP relay and only for ipv6 a full-fledged DHCP server. I would like to find confirmation of this information.

[Jaderson Pessoa]

I dont understand your doubt, could you clarify, please?

Because, i understood that you need just configure dhcp server on your ASR9001

[sergei-bilan]

Yes that's right, on the ASR 9001 IOS XR. As a DHCP server ipv4 to distribute the IP pool. But the documentation states only for DHCP relay settings.

[maileh · Accepted solution]

i have the same issue and i have been scrathing my head for few days now on this.

I think the Docs support and even the IOS XR version support the command  but not the actual service. The reason i say that i am refferring to DHCPv4 Server mode. I can see DHCP Discover Message coming to the router but there is no offer in return to that .....  

[John Patrick Lopez]

It is supported. We are using ours as DHCP server.