Firewall Blade Catalyst 6509

[mendezjm]

I have two firewall blade in a Catalyst 6059.

I have associate one fireblade to 3 vlans with the following commands.

firewall module 8 vlan-group 50

firewall vlan-group 50 55-57

I need to configure the second fireblade as secondary in High Availability ditribution but when Iassign the same vlans to module 9 it says that only one svi can appear.

Someone knows how to configure to fireblade modules?

[gfullage]

Follow the config guide and you should be OK:

http://www.cisco.com/en/US/partner/products/hw/switches/ps708/products_installation_and_configuration_guide_chapter09186a0080159cab.html

Look at the "Setting up a Single-Chassis Configuration" section specifically.

[mendezjm]

I have seen the following command

failover lan interface if_name

Is this command in the router or in the firewall.

If I'm able to introduce this command, will the error message abou SVI disapear?