cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
209
Views
0
Helpful
1
Replies

how do I use an old config file in cluster ?

Yves-Buecking_2
Beginner
Beginner

Hi,

I have an asa cluster, and saved the config on disk0 once a week.

Now I would like to replay the config from last week, but it doesn ?t work.

I thought when I configure the boot config statement pointing to the old config on disk0 it should work. but ist doesn ?t. The Secondary takes over, and then the Primary comes back, but with the old config.

How does is work ?

1 Reply 1

jbayuka
Contributor
Contributor

Disconnect the command switch from the member switches and physically remove it from the cluster. Insert the member switch in place of the failed command switch, and duplicate its connections to the cluster members. Start a CLI session on the new command switch.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: