cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
277
Views
0
Helpful
1
Replies

How to Use NAT to Direct User Based on the Destination Address?

rrgaines
Beginner
Beginner

The scenario is this, I need to use NAT to send a user connecting from the internet to IP address 1.1.1.1 if they have a destination address of 1.1.1.2. I would be setting up NAT on the 3640 router used for my internet connection. Is this possible and how would I accomplish this? Access list?

1 Reply 1

yusuff
Cisco Employee
Cisco Employee

You are looking at configuring NAT outside on the router. Here's a sample config;

http://www.cisco.com/warp/public/556/2.html

HTH

R/Yusuf

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: