Installing Symantec End Point Client on FMC

[NeWGuy1109]

Hello,

There is a requirement in the enviromnet to integrate the FMC with Symantec End Point Protection.. i dont see any option in FMC Webui to do this.. is it possible to install the symantec client for unix/linux based client via FMC CLI..

and most importantly does Cisco support Symantec Integration ? 

[Rob Ingram · Accepted solution]

Hi @NeWGuy1109 

The FMC is a harden appliance, it's not intended for any endpoint protection solution to be installed. It would not be supported and I wouldn't recommend you even trying.

HTH