hi ,yesterday I installed a ISE in VM server with ESX4.1,I can login the ise with the user I build it in CLI ,but I can't login it with IEor FIREFOX user the same user,why?
The Cisco ISE GUI is supported on HTTPS-enabled Mozilla Firefox version 3.x and Microsoft Internet Explorer version 8 (in Internet Explorer 8-only mode).
Note Cisco ISE GUI is not supported on Internet Explorer version 8 running in Internet Explorer 7 compatibility mode.
After you have installed Cisco ISE, you can log into Cisco ISE as described:
To log into the Cisco ISE GUI, complete the following steps:
Step 1 Enter the ISE URL in the address bar of your browser (for example, https://
The ISE login window appears.
Step 2 Enter admin in the Username field.
Step 3 Enter cisco in the Password field. This value is case-sensitive.
Note admin and cisco are the default values for the username and password that you must use to access the ISE user interface for the first time.
Step 4 Click Login or press Enter.
If your login is successful, you will be prompted to change your password.
Step 5 Enter your new password and re-enter it for confirmation.
You can now access the menus in the ISE user interface.
For more infor:
-Do rate helpful posts.
I am so sorry for reply this so long time ,I try to reinstall the ISE ande set the admin account different with "admin",But I just LOGIN the ISE with the account ,and without any promote to change the account.Now I can use the ISE normally.Thanks again.
No worries. If it's resolved, I would appreciate if you can mark this thread resolved so that other's can benefit from it.