I need to setup static NAT in order for a host on our network to communicate with a host on another network. Below is my setup;
Our Host----------Our Router------------------Their Router-----------Their Host
10.5.1.5 FA0:10.5.1.2 S0: ?
E0: 159.238.x.x E0: 159.238.x.x
I entered the following commands:
interface Ethernet0
ip address 159.238.x.x 255.255.255.248
ip nat outside
half-duplex
!
interface FastEthernet0
ip address 10.5.1.2 255.255.255.0
ip nat inside
speed auto
half-duplex
ip nat inside source static 10.5.1.5 159.238.x.x
If I do a sh ip nat trans, it shows the proper inside local and global address, but a sh ip nat stat shows no hits when I try to ping from the inside host to their router.
I'm new to NAT on Cisco, so I'm guessing that I'm missing something simple.
Thanks for any help.
Phil