10-24-2005 08:50 AM - edited 03-09-2019 12:48 PM
FTP not working, data channel not getting set up.
I did an outside capture and can see that although the inside addresses are being translated, and the control channel getting set up, when a PORT command is issued, the IP address in the command is the inside IP.
The server then responds with a
Response: 500 I won't op
10-24-2005 10:51 AM
Do you have fixup protocol ftp enabled? Where is the PIX in this config?
10-24-2005 12:25 PM
This actually is an ASA, running version 7. Fixup is now "inspect" and is supposed to be enabled by default. I.e. I have no explicit FTP configuration.
The ASA is the Internet firewall.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: