Hi, I have a pix 506 running ver 6.2(1), PDM Ver 2.0(1), 8Mbytes Flash, 32Mbytes Ram.
After some configuration change (3DES VPN) via telnet when I try to use PDM I receive the following error message:
Unsupported Commands
The Cisco PIX Device Manager (PDM) does not support the complete command set of the Command Line Interface (CLI). PDM cannot function normally when certain unsupported commands are in the running configuration. This has important implications when using PDM.
Where I can find the list of supported and unsupported commands for this pdm version and for the latest pdm version?
Thanks,
Leonardo