ping 501

[Danny Guillory Jr]

anyone know why i cannot ping my 501e

i have attached my current config

[Jon Marshall]

Are you trying to ping the outside interface ?

If so in your config

"icmp permit outside"

Jon

[Jon Marshall]

posted twice

[Danny Guillory Jr]

nope still not working and here is the new config

can anyone else ping it?

[Jon Marshall]

I can ping your default-gateway ie. 68.213.152.81 but not .84

Can you ping the default-gateway from the pix ?

What does the ouput of a "sh int e0" on your pix show ?

Can you also temporarily remove

"static (inside,outside) 68.213.152.84 10.7.2.13 netmask 255.255.255.255 0 0"

from your config.

Jon

[Danny Guillory Jr]

no i cannot ping the gateway from the pix

yes i can remove that line from the pix give me 2 min!

[Jon Marshall]

Sorry, just in case you missed it as i added it into previous post

"sh int e0"

Jon

[Danny Guillory Jr]

AB01-CC-PIX(config)# sh int e0

interface ethernet0 "outside" is up, line protocol is up

Hardware is i82559 ethernet, address is 0013.6070.a868

IP address 68.213.152.84, subnet mask 255.255.255.248

MTU 1500 bytes, BW 100000 Kbit full duplex

384 packets input, 28890 bytes, 0 no buffer

Received 47 broadcasts, 0 runts, 0 giants

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

6 packets output, 360 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 babbles, 0 late collisions, 0 deferred

0 lost carrier, 0 no carrier

input queue (curr/max blocks): hardware (128/128) software (0/1)

output queue (curr/max blocks): hardware (0/1) software (0/1)

[Jon Marshall]

How is the pix connected to the router - is it via a switch/hub or a crossover cable ?

Do you have access to the router or is this managed by your ISP ?

Jon

[Danny Guillory Jr]

the pic is connected to the dsl model via straight through cable

[Jon Marshall]

Just tried telnetting to default-gateway and it let me in. don't worry i logged straight out again - is this your ADSL router ?

Jon

[Danny Guillory Jr]

yes the gateway is the dsl router witch is 81

84 is the pix 501

[Jon Marshall]

How are the 2 connected to each other. If it is via a switch then you need to make sure the switch ports are in the same vlan.

Jon

[Danny Guillory Jr]

cable from port 1 of the modem to port 1 on the pix

[Jon Marshall]

When you say port 1 on the pix what is it labelled as - it needs to be eth0. Eth1 is the inside interface.

Jon