PIX command to show tunnel status up or down

[Kevin Melton]

I would like to ask if there is a specific command within the PIX OS that will allow me to show if the tunnels that I have set up for VPN from a remote PIX to the local one are active...

I have looked throught the show ? on the Pix but cannot determine...

You would think there would be a "show tunnel" command...

[shabib.syed]

show isakmp sa

This will show you all your vpn connections.

[Kevin Melton]

Thank You!

[ajagadee · Accepted solution]

Hi,

You can use:

" Show crypto isakmp sa " to see if your tunnel is up or not and,

"Show crypto ipsec sa" to see if the packets are getting encrypted/decrypted or not.

Regards,

Arul

[Kevin Melton]

Thanks Arul!