cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

5687
Views
0
Helpful
4
Replies
Beginner

PIX command to show tunnel status up or down

I would like to ask if there is a specific command within the PIX OS that will allow me to show if the tunnels that I have set up for VPN from a remote PIX to the local one are active...

I have looked throught the show ? on the Pix but cannot determine...

You would think there would be a "show tunnel" command...

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: PIX command to show tunnel status up or down

Hi,

You can use:

" Show crypto isakmp sa " to see if your tunnel is up or not and,

"Show crypto ipsec sa" to see if the packets are getting encrypted/decrypted or not.

Regards,

Arul

View solution in original post

4 REPLIES 4
Beginner

Re: PIX command to show tunnel status up or down

show isakmp sa

This will show you all your vpn connections.

Highlighted
Beginner

Re: PIX command to show tunnel status up or down

Thank You!

Cisco Employee

Re: PIX command to show tunnel status up or down

Hi,

You can use:

" Show crypto isakmp sa " to see if your tunnel is up or not and,

"Show crypto ipsec sa" to see if the packets are getting encrypted/decrypted or not.

Regards,

Arul

View solution in original post

Beginner

Re: PIX command to show tunnel status up or down

Thanks Arul!

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here