11-29-2004 09:02 AM - edited 02-20-2020 11:46 PM
Hi All,
How can you recover the password if you do not know the IP address of the PIX interface?
I cannot set up any server... (http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_password_recovery09186a008009478b.shtml)
I have a pix in my lab, but I need to reconfigure that.
How can I do it?
Thanks
11-29-2004 09:11 AM
Try putting a sniffer on the inside interface of the PIX and see if you can sniff and find out the IP address of the box.
Also in the link specified, you need a TFTP server which is a software you can download from the internet for free and run it on your laptop or PC.
Attached with this post is a TFTP software.
11-29-2004 05:06 PM
This is very easily done. All you do is boot into the monitor mode, and assign an ip address to the interface, tftp a password recovery file to the pix, and recover. Cisco provides the document on how to do this at
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: