cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

103
Views
0
Helpful
2
Replies
Beginner

PIX515E with 2 WAN Link

Hi All,

I have two difference WAN link (E1 & ADSL) with two difference subnet of Public IP Address (203.117.144.xxx & 203.118.40.xxx). How should I configure the PIX link to two routers and also direct the internal network traffic to the proper WAN link?

Example, E1 link is for webserver and Internet access will go through ADSL link.

Thanks

MK

2 REPLIES 2
Highlighted
Beginner

Re: PIX515E with 2 WAN Link

Hi,

There is only one way to fulfill your requirement is through routemap on Router. Configure default gateway on pix to ADSL router router. on ADSL router configure route map statement for your requirement.

Good Luck

Banno

Beginner

Re: PIX515E with 2 WAN Link

Hi,

Currently I'm using the leased line connection, if I change the default gateway to ADSL router, how to configure routemap on ADSL Router? Do you have any example?

The PIX's have 6 interfaces and the follow is my setting on each interfaces. outside(e0)-203.117.144.xxx, inside(e1)-192.168.101.xxx,

dmz(e2)-192.168.100.xxx,

state(e3)-192.168.253.xxx (failover)

Should i use the same IP range 203.117.144.xxx for the ADSL link instead of 203.118.40.xxx. From your expertise, what is the better solutions.

Thanks & Regards.

Lim

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here