cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
142
Views
0
Helpful
1
Replies
Highlighted
Beginner
Beginner

port security on a 6513

While telneted I implemented port security on a 6513 module with the following command:

set port security 6/1-48 enable age 2 maximum 4 shutdown 0 unicast-flood enable violation restrict timer-type absolute

I noticed an immediate delay (slowness) on the switch in response time for commands etc...

I disabled port security, and noticed an immediate increase (speed) in response times for commands.

any suggestions as to why it might be doing that?

1 REPLY 1
Highlighted
Participant

There might be a delay immediately after configuring port security.But as time goes on it has to come back to normal state.Try to restart the device on which the port security is configured.Refer URL

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00800b1500.shtml for speeding up the device.