I am Performing a software upgrade on a Cisco ASA running 8.0 to 9.1.
I know that the major change is the NAT configuration in this upgrade.
In the Pre 8.3 Version, below is the static NAT config. Here any traffic comes on the inside interface with the Source IP address y.y.y.y is translated to x.x.x.x and any traffic comes on the outside interface with the destination IP address x.x.x.x is translated to y.y.y.y
I mean, Does the traffic coming on the inside interface with the Source IP address y.y.y.y is translated to x.x.x.x and any traffic coming on the outside interface with the destination IP address x.x.x.x is translated to y.y.y.y
We are happy to share changes to the Cisco Threat Grid support experience! Our customers have spoken, and we have listened! You want a single, streamlined, easy to access tool to open, view, and update your cases across Cisco Services. That tool is Cisco’...
Where can I find out how to integrate my Cisco products with Threat Response?
There are quick start guides and instructional videos to help you get set up with your Cisco products and the Cisco Threat Response platform.
Inviting all Security & Networking professionals! We want you to tell us what devices you use to do your work and its screen resolution. Your response will help us improve network and security management tools.
Click here to take the 5-minute s...
This guide is intended to show some nifty and powerful use cases that a lot of customers either want or don’t know they want. There are tons of other content out there for specific knobs or capabilities, but this is looking to be a more complete...