Privilege level information

[gerardor884]

does someone knows what is the detail information of privilege levels 0 to 15?

what does privilege level 3?

what does privilege level 7?

 what does privilege level 15?

I am looking for the most basic level that permits show commands such as show ip route, show ip bgp summary, show cdp neighbors

Thanks

[Alex Pfeil · Accepted solution]

I couldn’t find exactly what you are looking for. Please check this out. Please rate helpful posts.

https://www.cisco.com/c//us/td/docs/switches/lan/catalyst3850/software/release/3se/security/configuration_guide/b_sec_3se_3850_cg/b_sec_3se_3850_cg_chapter_011.pdf#page4

[gerardor884]

alex it looks like the URL that you just provided is broken

Thanks

[Alex Pfeil]

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3850/software/release/3se/security/configuration_guide/b_sec_3se_3850_cg/b_sec_3se_3850_cg_chapter_011.pdf#page4

[Alex Pfeil]

I just checked the new one and it works.

[Francesco Molino · Accepted solution]

Hi

Privilege 15 means admin with full rights. Privilege 1 is user-level command only. Everything in between is up to you to configure on the switch to device what privilege can access what command. If you assign privilege 4 and commands for this privilege aren't defined, ios will go to lower privileve until it get one configured. This means, if you didn't configure any privilege and assign level 4 to a user, it will check 3 then 2 and finally 1 and assign level 1 commands to your user.
If you had configured 3, then commands 3 were assigned.
Privilege 0 has only few command.

Take a look here:
https://learningnetwork.cisco.com/docs/DOC-15878

https://www.cisco.com/c/en/us/support/docs/security-vpn/terminal-access-controller-access-control-system-tacacs-/23383-showrun.html

[gerardor884]

Thank you !

[Francesco Molino]

You're welcome