RAS access using 3640

[blackhurstt]

I would like to know what the hardware and software requirements are for a 3640 when using it for RAS provision with authentication using RSA Secure ID?

Does the 3640 have provision for RSA as standard?

If so is this standard IP software or IP Plus?

The 3640 will have a pri card and Digital modem card installed for remote home users to dial into the network.

Thanks

[wdrootz]

You can use Feature Navigator to determine which IOS to use (www.cisco.com/go/fn) But it looks like a basic IP IOS is all you need to enable AAA. 12.0.9 is the latest General Deployment code for this and requires 8 MB Flash and 32 MB RAM.