02-14-2007 04:29 PM - edited 02-21-2020 02:52 PM
Hi,
I ran into an issue with a customer where we setup his remote-access vpn via ASDM and used the same name (eg. itvpn) for the group-policy and tunnel-group. After putting the ASA on the network we were able to connect via VPN client, however we never saw any traffic being decrypted at the client end.
I then removed all the config from the CLI related to the remote-access vpn and put it back in via the CLI (instead of ASDM). The only difference I can see between the two configs is the second one I used a different name for the group-policy (eg. itvpnpolicy) and tunnel-group(eg. itvpn). We were then able to see decrypted packets at the client end and everything worked.
Does anyone have a working configuration where they are using the same name for both the group-policy and tunnel-group? Am I nuts in thinking you can't use the same name for both? Just curious if maybe I'm missing something when comparing the two configs.
Thanks!
Brad
Solved! Go to Solution.
02-14-2007 05:03 PM
Hi Brad,
I have seen many setups working with the same name. So its fine. You are definitely missing something else.
Regards,
Kamal
02-14-2007 05:03 PM
Hi Brad,
I have seen many setups working with the same name. So its fine. You are definitely missing something else.
Regards,
Kamal
02-14-2007 05:45 PM
Ok, Thanks Kamal. I appreciate the quick response too!
Brad
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: