11-01-2018 05:12 AM - edited 02-21-2020 09:30 PM
We have migrated from Cisco ACS TACACS+ to Cisco ISE TACACS Device Administration. We were able to search for network devices within ranges on the old system but not with ISE. For example, in the old system if you had 10.10.10.7-10, you could search for 10.10.10.8 and find it. We cannot do this with the new system which is 2.3. Are we doing something wrong?
Solved! Go to Solution.
11-01-2018 08:47 AM
i tried with acs5.8 and ISE2.3
it seems ISE doesn't accept it, unlike ACS.
you might need to open case if you really need this on your system.
11-01-2018 09:29 AM
Thanks - we'll look at opening a case.
11-01-2018 06:57 AM
you can filter on the ip/mask
what is happening when you do this filter ?
11-01-2018 08:28 AM
11-01-2018 08:47 AM
i tried with acs5.8 and ISE2.3
it seems ISE doesn't accept it, unlike ACS.
you might need to open case if you really need this on your system.
11-01-2018 09:29 AM
Thanks - we'll look at opening a case.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: