01-17-2020 05:57 PM - edited 01-17-2020 06:11 PM
Hello,
I'm trying to do a tunnel between two routers, where the objective is communicating their loopbacks. Both loopbacks use IPv6, and both tunnels use EIGRP to communicate their loopbacks.
When I finished it, both tunnels could talk each other if they use IPv6. But when I try to share their loopbacks using EIGRP, both routers cannot recognize each other as neighbors.
I have put an image with the topology, the packet tracer file where I'm doing it and the configuration from the devices.
Regards,
Franco Riggio
Solved! Go to Solution.
01-17-2020 06:41 PM
Some time reload do wonders for us :D
01-17-2020 06:22 PM
Excuse me, but I have solved it. The problem was that at first EIGRP processes could not talk to each other because I did not write the command tunnel mode ipv6ip. But after doing some tests, I reloaded the routers and it worked!
I share you what I did!
Thank you
01-17-2020 06:41 PM
Some time reload do wonders for us :D
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide