cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
227
Views
0
Helpful
4
Replies
Highlighted
Beginner

User privilege

Hi

I have created a local user ABC on Cisco router with privilege 6 but when I login using ABC and apply enable command then I am able to run any command so my question is

Is the “enable” command after login using user ABC with privilege leve 6  equivalent to level 15 privilege?

 

username ABC privilege 6 password 0 cisco

SW3#telnet 10.10.10.100
Trying 10.10.10.100 ... Open


User Access Verification

Username: ABC
Password:
SW2#

SW2#enable
Password: xxxxxxxx

 

SW2#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
SW2(config)#

 

Please advise

4 REPLIES 4
Highlighted
Cisco Employee

Can you post:

1. The output of "show privilege" after you enter the enable secret

2. Post the full device config

 

Thank you for rating helpful posts!

Highlighted
Beginner

yeah I also have this problem... i seem to be able to create multiple user accounts but they all seem to use the same enable secret... which of course has a privilege level of 15...

I need to prevent a certain user from getting into config mode...

any ideas anybody?

Thanks

Highlighted

Please post your configs here. 

Highlighted

I can't because the config is in use on a live switch...