cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3604
Views
0
Helpful
2
Replies

Assigning IP address ASR 900

aamirkiani
Beginner
Beginner

Hi,

its possible i can assign IP address to Gigabit Interface in ASR 900.we just need to test it in a lab for testing purpose only.

Thanks in advance

Aamir

***************************************************************************************

ASR-900(config)#interface GigabitEthernet0/0
ASR-900(config-if)#ip addr
ASR-900(config-if)#ip address 192.172.1.1 255.255.255.0
IP address config under this interface is not supported on ASR901
ASR-900(config-if)#

************************************************************************************

1 Accepted Solution

Accepted Solutions

julijime
Cisco Employee
Cisco Employee

Hi aamirkiani,

Unfortunately you cannot assign an IP address to that interface. ASR901 supports SVIs for routing, so you can configure an interface vlan and then assign an IP address.

http://www.cisco.com/c/en/us/td/docs/wireless/asr_901/Configuration/Guide/b_asr901-scg/b_asr901-scg_chapter_010010.html

HTH

View solution in original post

2 Replies 2

julijime
Cisco Employee
Cisco Employee

Hi aamirkiani,

Unfortunately you cannot assign an IP address to that interface. ASR901 supports SVIs for routing, so you can configure an interface vlan and then assign an IP address.

http://www.cisco.com/c/en/us/td/docs/wireless/asr_901/Configuration/Guide/b_asr901-scg/b_asr901-scg_chapter_010010.html

HTH

I was able to create a VLAN and assign an IP to the VLAN. I however could not assign the VLAN to the interface. Could you clarify that step please?

 

Here was my result trying to assign the VLAN to interface.

 


Router(config-if)#do sh run int vlan 10
Building configuration...

Current configuration : 59 bytes
!
interface Vlan10
ip address 10.1.1.1 255.255.255.0
end

Router(config-if)#interface gigabitEthernet 0/0
Router(config-if)#switc
Router(config-if)#switchport acc
Router(config-if)#switchport access vl
Router(config-if)#switchport access vlan 10
This command is not supported.
Router(config-if)#