Hi, Can i install Subscriber Manager (SM) on the existing Collection Manager (CM) server?Can SM and CM work properly in one server?Any input is appreciated. Thank you
I have a SCE1000 running 3.5.0 (or 3.1.7), and every time it reboots, it goes into recovery mode. When I connect, it prompts for the initial setup questions, and when it tries the save them, most of them fail because it is in recovery mode. Also when...
Hi,My Question is :GSR IOS 12.0.33S2 (PRP-2) support SPA-5X1GE-V2?I using software advisor -> choose Hardware/software -> choose 12406 router.I choose 12000/6-DC,PRP-2, 12406E-SFC=,12406E-CSC=,12000-SIP-601=, SPA-1X10GE-WL-V2=Then It give me the IOS ...
HIAs there is a plan to upgrade from IPV 4 to IPV 6 want to make sure if the system need to be upgrade to support IPV 6the version of Rogger A,B is MS Win 2003AWSA and B MS wind 2003CM A&B is 4.1 Windows 2000IVR A and B Windows 20001. Current systems...
We have rtr configured on some of our 3660 and 2600 routers, when you do a show rtr config it displays the config output. However, there is no actual rtr configuration in the running/startup config, no command lines relating to rtr whatsoever. The IO...
Hi.could you somebody help me saying if it is possible to mark paquets of a GRE tunnuel in a router in the middle of the tunnel? Can use that mark latter when the traffic leaves the tunnel?. Thanks
Hello,I am developing an ISG/Broadhop SME solution to offer some differentiated services for broadband customers.The ISG/SME integration is working ok: As soon as the subscribers connect to the network they are redirected to the SME portal (PLAN port...
Hi, I am new to MPLS IP VPN and have a basic question. Can two different IP VPN with the same BGP ASN communicate to each other ? If yes, this would presumably done at the ISP site. What would they do to make this happen ? ie) redistribution ? Th...
Getting the below error message when I apply the following command under interface LineCard 0 'connection-mode inline-cascade physically-connected-links priority primary on-failure bypass'### command ###SCE2020-3(config if)#connection-mode inline-cas...
Can someone tell me what ip base version does and Sp services version does.. in most cases which is the best option under which circumstance please, thank you.Here we talking about an 1841 series router e.g 12.3 ip base and 12.4 sp services..
Hello!There are some questions about ASR & licences:1. If i want to use ASR1000 as aggregator of pppoe connections without using isg features, do i have to buy BB right-to-use licences and per-subscriber ones?2. Do i have to buy FW licence for using ...
Hi all, I have SCE deployment in my customer's environment. After upgrade the protocol pack (SPQI file), I can't find any update information from "show version". Is there any way to verify if the protocol pack update success?Thanks.
