Tengo un cable modem el cal esta en Partial-Mode y al verificar con el comando show cable modem verbose me topo con el siguiente resultado:Partial-Mode Information : reason 0x1 failed-tcs 0x1Me gustaria saber que significa, ya que he busca...
hi alli want to ask about dscp how many markfings it can make whgen using it ???as i understood i have efaf1-4cs1-7which in total about 18but the question is whhy there is 64 value can be put ???i may have some missunderstoodwish to clarify me=====...
With Ron Weaver Welcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to learn and ask questions about PowerVu Network Control System. Cisco expert Ron Weaver covered the basic PNC operation, focusing on decoder ...
I confirmed Saturday that there is a serious cue trigger (open collector) output problem from D9854s when upgraded to APP V4.00 and FPGA FX100 when upgraded to R35B5. Issue initially reported by one of our affiliates through Cisco TAC after they had ...
Hello All,We have noticed that audio is not in sync with the video for one of the encoded streams.The basic configuration for this servie is set to passthrough and all the delay settings (relative delay and external delay) are set to 0.of course, its...
Hi recently in reporter appears some weird table at the end of the "Multi Package Bandwidth per Service" report (RPT_PUR). The symptom is, that some of the services are named correctly, some of them are denoted with numbers, like this:Names are O...
We recently experienced a total loss of WGN America HD program audio on our downlink monitoring system. Master Control (MC) operator confirmed audio was present at the output of the MC plant. Operator replaced the primary audio processing chain (Line...
what importance source ip has in icmp packetand how it effects the resultsAs i am having completly different results to same destination with different source ipping generated by same router towards same destination router over same linkping 10.10.10...
hi, we have this configuration..policy-map type control DHCP class type control IP_UNAUTH_COND event timed-policy-expiry 5 set-timer IP_UNAUTH_TIMER 1 10 service disconnect ! class type control always event session-start 5 authorize aaa list AUTHO...
Hi, We are integrating Cisco ISG (IOS XE - ASR1001) with AAA and Policy Server. we have below to specific service provider requirement. 1. TAL - Transparent Automatic Subsriber for Range of IP or Pool of IP - how we add such identifier in Policy/...
Good day.Can't get the prepaid feature on ISG to work.I've got virtual BRAS on a base of GNS3 emulating Cisco 7200:R2#sh verCisco IOS Software, 7200 Software (C7200-ADVIPSERVICESK9-M), Version 12.2(33)SRD3, RELEASE SOFTWARE (fc3)Technical Support: ht...
Hello,Does anyone know the support level of ipv6 in the Service Control Engine products ?Can it classifiy ipv6 packets and also reconize the applications inside the ipv6 packets ?I'm searching for information of similar products like Packetshaper, wh...
Hi , I have high cpu constantly caused by ip input CPU utilization for five seconds: 45%/9%; one minute: 52%; five minutes: 60% PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process 201 1650855401671097443 98 23.75% 22.92% ...
