I have a CBT (Cisco Broadband Troubleshooter) v 3.4 apllication installed in our network. However, it can't read MC20x20 Linecard in the spectrum analyzer for the example. I read in the documentation that is supported. In our system, it only can read MC5x20.
Is there some configurations to do that?
please help me if you have some experience to solve this issue. thank you
XR-vm - CLI's
look for any process crash, review time stamp[if it is too old, then no immediate action needed]
verify if standby state is Ready and NSR-Ready
show proc cpu | exclude " 0%"
It's been a long standing ask for XR to support conditional route advertisements in BGP.
The expected option of using the
option in RPL currently can only be used at the default-inf...
On IOS-XR, Quality of Service has an extension to WRED (Weighted Random Early Detection) called Explicit Congestion Notification (ECN). ECN will mark packets instead of dropping them when the average queue length exceeds a specific threshold value. When c...
Technical Guide to Pre-Defined NAT.
In traditional NAT, due to the government regulations logging the CGN translations is mandatory and this is a huge cost incurrence. In Pre-defined NAT, the translations are known upfront, hence there is no nee...