ā10-01-2013 09:47 PM - edited ā03-01-2019 02:42 PM
Hi!
Cisco SCE 8000 working normally while traffic through it not pass. When i connect optical links and start passing traffic throught cisco, i have a problem. SCE watchdog run software reboot with error:
2013-09-30 13:54:40 | FATAL | CPU #000 | A problem occurred in the SCE8000 Service Control Module Extended (SCM-E) slot 1 ,Please report to Cisco's customer support.
2013-09-30 13:54:40 | ERROR | CPU #000 | SE Watchdog Module: An Error occurred. Please report to Cisco's customer support
2013-09-30 13:54:40 | ERROR | CPU #000 | SE Watchdog Module: An Error occurred. Please report to Cisco's customer support
2013-09-30 13:54:41 | WARN | CPU #000 | SE Watchdog Module: A problem occurred. Please report to Cisco's customer support
2013-09-30 13:54:41 | INFO | CPU #000 | Party data base was closed.
In debug file i found:
Interrupt Received from: SimbaDPT[0].Tx[0].CTX_ISR.ECCMultiErrorInt - description: RLDRAM ECC multi bit error interrupt.
What the problem could be?
ā10-03-2013 04:40 AM
Hi Mike,
Which SCOS version do you use? We have such issue with SCOS 3.8.0. There are no problems after upgrade to 3.8.5.
ā10-08-2013 06:50 PM
I have tried 3.7.2, 3.8.5, 4.0.0. Unfortunately, the result is the same. I think that hardware problem (RAM).
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: