How to prevent new cable modems to register on a downstream channel reached full rate on the ubr10012 CMTS?
I mean, how to configure CMTS to automaticaly order Cable Modems to register in a second 252QAM downstream channel when the first is reached its maximum full rate?
Ie, If there are 30 Cable Modems using the first Downstream Channel and this channel reaches its maximum data rate, the next (31st) must to automaticaly use the second downstream channel! How can I do it on the ubr10012?
XR-vm - CLI's
look for any process crash, review time stamp[if it is too old, then no immediate action needed]
verify if standby state is Ready and NSR-Ready
show proc cpu | exclude " 0%"
It's been a long standing ask for XR to support conditional route advertisements in BGP.
The expected option of using the
option in RPL currently can only be used at the default-inf...
On IOS-XR, Quality of Service has an extension to WRED (Weighted Random Early Detection) called Explicit Congestion Notification (ECN). ECN will mark packets instead of dropping them when the average queue length exceeds a specific threshold value. When c...
Technical Guide to Pre-Defined NAT.
In traditional NAT, due to the government regulations logging the CGN translations is mandatory and this is a huge cost incurrence. In Pre-defined NAT, the translations are known upfront, hence there is no nee...