Cisco Community
English
Register
We're here for you! LEARN about free offerings and business continuity best practices during the COVID-19 pandemic
Register
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
663
Views
0
Helpful
0
Replies
Highlighted
nihit-tandon
Beginner
Beginner
‎09-26-2012 10:40 AM
‎09-26-2012 10:40 AM

L2 circuit MAC limitation

Hi All,

In case  there is a limitation on the number of MAC  by Service Provider on a point to point circuit,

Can this be overcome by terminating the link on a router , so that only  the router MAC will traverse over the media. 

Pls let  me knw.

thanks,

Everyone's tags (5)
0 Helpful
Reply
Latest Contents
performing a manual iPXE boot (eXR password/disaster recover...
Created by xthuijs on 05-28-2020 05:38 AM
1
5
1
5
CCO documentation lists out the ability to do a password recovery for eXR with a ZTP/PXE boot. One can also perform the operation manually, like a "turboboot" for classic XR in this facinity. this procedure will wipe out the complete system and install a... view more
Introduction to MPLS LDP and MPLS-TE and SR and SR-TE (color...
Created by smilstea on 03-24-2020 04:25 PM
1
5
1
5
Hi everyone, Below is a link to a video showing how to analyze traceroute output in L3VPN and look up CEF forwarding and MPLS/TE/SR/SR-TE forwarding for labels through a domain. Some basic examples of traffic engineering are used but the concepts lend the... view more
[CVIM] Pod health check
Created by gosekar on 02-10-2020 12:24 AM
0
0
0
0
Introduction This document summarises various health checks that can be done on a Cisco VIM pod.   Cloud-sanity Cloud sanity checks the health status of network, storage and various openstack infrastructure components like mariadb, rabbitmq etc.... view more
Hardware Upgrade from RSP440 to RSP880-LT
Created by pallu on 02-06-2020 09:23 PM
0
25
0
25
Prerequisites        The following pre-requisites are necessary for the migration from RSP440 to RSP880-LT to be successful. Make sure that you have console access to the router. Verify that the system is running a minimum o... view more
BGP Flowspec implementation on Cisco 8000 platforms
Created by yosef_manasseh on 01-29-2020 01:21 PM
0
0
0
0
Feature Description     BGP flowspec in a nutshell is a feature that will allow you to receive IPv4/IPv6 traffic flow specification (source X, destination Y, protocol UDP, source port A .. etc) and actions that need to be taken on that traffic (... view more
CreatePlease to create content
Discussion
Blog
Document
Video
Content for Community-Ad

Cisco COVID-19 Survey