Hello. Is it possible to make a Layer 2 tunnel pass traffic from & to a bridge group?
The following example doesn't work:
interface Vlan1
no ip address
bridge-group 1
!
interface Vlan2
no ip address
xconnect 10.200.0.1 1 encapsulation l2tpv3 pw-class LAN2LAN
bridge-group 1
Both SVIs are up/up, xconnect is up, tunnel works, bridging between VLANs works. But frames from VLAN 1 don't enter the tunnel, and frames received via the tunnel don't get to VLAN 1.
We're generally not limited to L2TPv3. Any ideas? Thanks and best regards.
