cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1167
Views
0
Helpful
1
Replies

line/path code violation, Slip Secs

OMAR CANDARAVE
Level 1
Level 1

Hi all,

I am having issues with one circuit, it has a lot of line and path code violations, slip secs, line errors, etc

E1 0/0/1 is up.

  Applique type is Channelized E1 - balanced

  No alarms detected.

  alarm-trigger is not set

  Version info Firmware: 20100222, FPGA: 13, spm_count = 0

  Framing is NO-CRC4, Line Code is HDB3, Clock Source is Line.

  Data in current interval (187 seconds elapsed):

     3 Line Code Violations, 82 Path Code Violations

     7 Slip Secs, 0 Fr Loss Secs, 2 Line Err Secs, 0 Degraded Mins

     9 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs

  Total Data (last 22 15 minute intervals):

     3780 Line Code Violations, 9605 Path Code Violations,

     718 Slip Secs, 5 Fr Loss Secs, 279 Line Err Secs, 4 Degraded Mins,

     981 Errored Secs, 0 Bursty Err Secs, 5 Severely Err Secs, 31 Unavail Secs

The Carrier said tha they have all correclty configured, all the parameters are correct and that the problem is on our side.

we have this configuration:

card type e1 0 0

interface Serial0/0/1:0

description ****

bandwidth 512

ip address 172.31.227.217 255.255.255.252

no ip redirects

encapsulation ppp

no cdp enable

service-policy output AVPN

Controller E1 0/0/1

framing NO-CRC4

channel-group 0 timeslots 1-8

Could you guys please help to understand what is happening?

Thanks in advance

1 Reply 1

drubery
Level 1
Level 1

You do not state what the carrier wants for protocol/framing/linecode.  If you are not configured ust as they are it could explain what you ae seeing.  This could also be caused by modems, cabling and media conversion.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: