04-08-2016 07:45 AM - edited 03-01-2019 03:00 PM
Hi ciscomates!
Somebody knows if there is a limitation in bridge-domain under service instance?
I have a Cisco 7606S with WS-SUP720-3B, 7600-SIP-400 and SPA-5X1GE-V2
I have a config like this,
interface GigabitEthernet3/3/4
mtu 9216
no ip address
negotiation auto
service instance 101 ethernet
encapsulation dot1q 1034 second-dot1q 4
rewrite ingress tag pop 2 symmetric
bridge-domain 15 split-horizon
!
But after 120 service-instance with brigge domain I have this error,
%bridge-domain rejected: unable to allocate port
Somebody can help me?
Thanks in advance.
Solved! Go to Solution.
05-04-2016 11:58 AM
Hello David
Are you using VPLS or EoMPLS circuits with EVC towards the AC's.
if yes, then the max that can be configured on SIP-400 card is 120. Please refer to the below CCO documentation for reference.
http://www.cisco.com/en/US/products/hw/routers/ps368/module_installation_and_configuration_guides_chapter09186a0080440138.html#wp1192865
Hope this answers your question.
Regards
Vinit
05-04-2016 11:58 AM
Hello David
Are you using VPLS or EoMPLS circuits with EVC towards the AC's.
if yes, then the max that can be configured on SIP-400 card is 120. Please refer to the below CCO documentation for reference.
http://www.cisco.com/en/US/products/hw/routers/ps368/module_installation_and_configuration_guides_chapter09186a0080440138.html#wp1192865
Hope this answers your question.
Regards
Vinit
05-10-2016 08:16 AM
Thank you Vinit, that's exactly my problem.
Regards.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide