Good morning I'm having problems configuring out
of band clocking between two MWR-2941
I have configured one MWR-2941 to
Remote
recovered-clock slave
!
interface Virtual-Cem 0/24
cem 0
xconnect 10.10.10.2 7600 encapsulation mpls
network-clock select 1 PACKET-TIMING
network-clock-select hold-timeout 900
the Master Router is getting it clock signal from an E1/T1 interface
MASTER
controller E1 0/0
clock source internal
cem-group 0 unframed
description Clocking-Signal
!
controller E1 0/13
clock source line
cem-group 0 unframed
interface CEM0/0
description Clocking-Signal
no ip address
cem 0
xconnect 172.16.20.26 7600 encapsulation mpls
!
!
interface CEM0/13
no ip address
cem 0
xconnect 172.16.20.26 11591 encapsulation mpls
with this configuration i can't get any clocking at the remote site. I have configured this between a Cisco 7609 and the MWR-2941 without problem, but in the Cisco 7609 I can create another virtual-cem interface. But I can't find a way to create a virtual-cem in the MWR-2941 that should be working as the clock master.
Any help will be greatly appreciated.
Thank you very mucy.