Hallo everyone ,
i have a 10 G interface for Core Device (Catalyst 6880), i want to check if everything ok on this Interface , but theres hight Output Drop Number i dont know if this still normal in compare with all Output Packets ?? , this interface is connected with Cisco UBR 10012.
i restored the interface Counter before 3 Weeks and heres the Show interface command for this Interface .
the second question what mean these pause input Number??
# Show interface Te5
line protocol is up (connected)
Hardware is C6k 10000Mb 802.3,
MTU 1500 bytes, BW 10000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 64/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 10Gb/s, media type is 10Gbase-SR
input flow-control is on, output flow-control is off
Clock mode is auto
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters 3w3d
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 6740061
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 431000 bits/sec, 112 packets/sec
5 minute output rate 2515016000 bits/sec, 241906 packets/sec
288338483 packets input, 141872230298 bytes, 0 no buffer
Received 31 broadcasts (0 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 177 pause input
0 input packets with dribble condition detected
546855141188 packets output, 722892128881803 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
