Hi All:
We have several thousand DMR racks built from DPC3010s that support US freqs to 88MHz. However, we are seeing an issue with the CM not properly setting this capability during registration. For empale: debug cable tav and debug cable registration on the cbr-8 platform for a DPC3010 Cisco DPC3010 DOCSIS 3.0 Data Modem <<HW_REV: 1.0; VENDOR: Cisco; BOOTR: 2.3.0_R1; SW_REV: d3000-c1000r5593-140408a; MODEL: DPC3010>>:
CLC 0/0: Apr 16 17:47:34.529 PDT: US Freq Band Support : 0 <-- This should be 1 for capability up to 88MHz.
Is there a MIB or TLV required on the CM config file to enable the proper capability setting?
Thanks
Alan