I’m looking for unidirectional scaling numbers for ASR1k.
Control plane scaling numbers (number of BGP sessions/VRFs/VRRPs/BFDs/RSVP-TE head-end/etc…) on RP2 and RP3 (both 8Gig).
Data plane scaling numbers (number of Policers/Queues/Routes(FIB)/etc…) on ESP200 I have found some scaling numbers online for the ESP200 as a whole, but I’d like to also get the per Yoda block (Flow Processor Engine & Traffic Manager) numbers if possible.
Are there any show commands I could use to get the at least data-plane numbers form the platform directly?
CCO documentation lists out the ability to do a password recovery for eXR with a ZTP/PXE boot.
One can also perform the operation manually, like a "turboboot" for classic XR in this facinity.
this procedure will wipe out the complete system and install a...
Below is a link to a video showing how to analyze traceroute output in L3VPN and look up CEF forwarding and MPLS/TE/SR/SR-TE forwarding for labels through a domain. Some basic examples of traffic engineering are used but the concepts lend the...
This document summarises various health checks that can be done on a Cisco VIM pod.
Cloud sanity checks the health status of network, storage and various openstack infrastructure components like mariadb, rabbitmq etc....
The following pre-requisites are necessary for the migration from RSP440 to RSP880-LT to be successful.
Make sure that you have console access to the router.
Verify that the system is running a minimum o...
BGP flowspec in a nutshell is a feature that will allow you to receive IPv4/IPv6 traffic flow specification (source X, destination Y, protocol UDP, source port A .. etc) and actions that need to be taken on that traffic (...