cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
608
Views
0
Helpful
1
Replies
Highlighted
Beginner

SCE 2020 not shaping uploads

Wonder if anyone has advice on this,

We have configured a package for testing purposes to provide a PIR of 5mb/s upload and 5mb/s download. Its a very basic package that just matches all traffic and is then suppose to rate limit said traffic. What we have is that when doing a basic test to speedtest.net that downloads seems to be rate limited to a certain extent (Getting about 8mb/s at start and then drops down to 5 towards the end of the test) but with upload we are always getting a lot more, sometimes as high as 80mb/s but usually around 10mb/s, only on some occasions close to 6 or 7 but never as low as 5. Could this be a buffering issue or is there something else we need to set?

Thanks

PJ

1 REPLY 1
Highlighted
Beginner

Nobody seen this behaviour? is this common?

Content for Community-Ad