11-28-2008 04:42 AM - edited 03-01-2019 02:09 PM
Hi Guys I have an SCE 2000 which failed after installation. the problem is i cant get access through the console, it does not respond. when i get access through the AUX port, the first prompt is [VxWorks Boot] if i try to reboot it gives the error cant load bootfile.
kindly assist
11-27-2009 05:17 AM
Hi everybody,
This is an old post, but I have the same problem... somebody knows how to boot the SCE from the VxWorks console?
Regards,
Gustavo.
02-04-2010 02:14 PM
Hi Gustavo,
Did you get an answer to this problem?
I have the same problem !!!
02-05-2010 04:23 AM
Hi,
First you need is a file named "SEos"... I looked for this file in the download area of Cisco could not find it.
Then the procedure is very similar to others using VxWorks...
Regards,
Gustavo.
06-30-2010 06:25 AM
If you have a running box, you can extract the OS file and boot it with TFTP.
The file name is 'seos'.
09-30-2011 07:58 AM
Hi, I have the same issue, but the network card doesnt boot, how can I get the management Ethernet interface to come up in the VX works boot mode so I can copy the seos file from another working device?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: