We have some SCE2020's setup sending RDR's to a CM running mysql. Our SCE has 2 zones, one for national traffic plus the default zone.
under classification we have services configured for the National zone and then also the same services matching * under zone settings to match the default zone. When we view reports (Global bandwidth per service) all traffic just shows under the national zone and nothing shows any traffic for the default zone.
Has anyone come across this, why would my International traffic not show in my reports. When I test the policies im definitely matching traffic to the right policy and being shaped accordingly.
I have a package setup that has a 10Mb/s pipe for national and 1Mb/s for international, when I do testing I get shaped to these values but when I check the reports the reports only shows traffic for the national component.
Hi Everyone, Would like to extend my thanks in advance for anyone offering assistance. As the subject hints, anyone here know of a way to convert IOS configs to XR config? I seen and heard about SOX tool but i am unable to find it. I also tried ...
When I run the command 'sh controllers fabric fia q-depth location 0/0/CPU0' or any 0/X/CPU0 and see the following, what exactly does it mean? RP/0/RSP0/CPU0:Router#sh controllers fabric fia q-depth location 0/0/CPU0********** FIA-0 **********Categor...
Symptoms: the root password can't log in by GUI Solution:1) login CLI as admin2) write command "ncs webroot enable" without qutations3) we can check the status by "ncs webroot status" hope this will help someonethanks
ISO images are as close as we can get to the old school classic IOS images from back in they day.
Doing upgrades by putting a new image on the flash, changing the boot pointer and reload was and is still the walhalla of Cisco based devices.