cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1075
Views
0
Helpful
1
Replies

SM: Error while sync with SCE [Quarantine mode]

aquafon123
Beginner
Beginner

[SCE 8000]

System version: Version 3.6.5 Build 489).

[SM]

./p3sm --version

3.6.5 Build 300

[Problem desc]
I have 2 SCEs, not in cascade mode.
SCE S132SCE8000T2  gone to quarantine mood and can't auto-recover.
./p3log -> log.txt says (attached):
2011-06-01 13:24:00 | ERROR | SM    | SCE S132SCE8000T2 has been put in quarantine for the next 7680 seconds - Failed to perform logon operation
I moved SCE back to normal operation using ./p3net --connect --ne-name=S132SCE8000T2 and quarantine reset.
Now situation as follows:
Synchronization Status: Not-done(100% failures) for S132SCE8000T2.
I try to use ./p3subs --resync --ne-name  with no effect:
>./p3sm --resync --ne-name=S132SCE8000T2
Error - Failed to synchronize S132SCE8000T2
S132SCE8000T2 is not active
How can I resolve the problem and why the failure occured?
>
>
>./p3net --show-all --detail
==============================================================================
| Name             | Host             | Conn-    | Sync-    | Domain          |
|                  |                  | Status   | Status   |                 |
===============================================================================
| S132SCE8000T1    | 172.24.7.17      | up       | done     | subscribers     |
| S132SCE8000T2    | 172.24.7.20      | up       | not-done | subscribers     |
Command terminated successfully
>./p3net --show --ne-name=S132SCE8000T2
Network Element Information:
============================
Name:        S132SCE8000T2
Host:        172.24.7.20
Ip:          172.24.7.20
Port:        14374
Status:      Connection ready
Type:        SCE8000
Domain:      subscribers
Synchronization Status: Not-done(100% failures)
Redundancy Status: Standalone
Quarantine Status: ok
Command terminated successfully
>./p3net --show --ne-name=S132SCE8000T1
Network Element Information:
============================
Name:        S132SCE8000T1
Host:        172.24.7.17
Ip:          172.24.7.17
Port:        14374
Status:      Connection ready
Type:        SCE8000
Domain:      subscribers
Synchronization Status: done
Redundancy Status: Standalone
Quarantine Status: ok
Command terminated successfully
1 REPLY 1

Tom Debruyne
Cisco Employee
Cisco Employee

Hello,

For this one, I think you will need to open a service request with TAC.

I would look at the umlog on the SCE and the SM, as well as the dbglog.txt from the SCE.

These can be found in the support files:

SCE#logger get support-file ftp://user:passwd@10.10.10.10/./support-file.zip

  • ~pcube/sm/server/bin//p3sm --extract-support-file -o SM-Support.zip

  • Also, run a tcpdump on the SM when trying to resync and look for anomalies in the connection.  Look also for the CPU usage on the SCE.

    Regards,

    Tom Debruyne

    Getting Started

    Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: