So I'm new to the 12K series for linecard firmwares. I've been tasked to upgrade all the ROMs and such in prep for migration from IOS to IOS-XR.
The requirements are:
Line cards (LCs)
For Engine 3 line card:
–Maintenance Bus (MBUS) Agent Software-RAM version 04.06, ROM version 04.06
–ROM Monitor version 17.1
–Fabric Downloader - RAM version 8.0, ROM version 8.0 (The ROM version will be the same as the RAM version if upgraded.)
Route processors (RPs)
For Performance Route Processor 2 (PRP-2):
–Maintenance Bus (MBUS) Agent Software-RAM version 04.06, ROM version 04.06
– ROM Monitor version 1.24
I am currently at:
rotgsr-2#show diags | include SLOT | ROM Monitor
SLOT 4 (RP/LC 4 ): Performance Route Processor
ROM Monitor version 1.24
SLOT 5 (RP/LC 5 ): 4 Port ISE Gigabit Ethernet
ROM Monitor version 19.1
rotgsr-2#show diags | inc SLOT| MBUS | Fabric Downloader
SLOT 4 (RP/LC 4 ): Performance Route Processor
MBUS: MBUS Agent (1) 73-8048-07 rev A0 dev 0
MBUS Agent Software version 2.72 (RAM) (ROM version is 3.69)
SLOT 5 (RP/LC 5 ): 4 Port ISE Gigabit Ethernet
MBUS Agent Software version 2.72 (RAM) (ROM version is 3.69)
Fabric Downloader version used n/a (ROM version is 7.9)
rotgsr-2#dir
Directory of disk0:/
1 -rw- 6892544 Oct 8 2010 13:38:58 -04:00 c12k-fpd-pkg.120-33.S7.pkg
2 -rw- 31299072 Oct 8 2010 13:44:50 -04:00 c12kprp-p-mz.120-33.S7.bin
How do i find the correct IOS load to help upgrade to the correct firmwares? Obviously, the latest 12.0S isn't enough. And why does the Fabric Downloaded say version n/a? Did I miss a step?
Thanks,
Greg