cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
439
Views
5
Helpful
1
Replies

1230 Series LAP and WCS 6.0.199.0 Heatmap Problem

drakow
Level 1
Level 1

I recently upgraded from WLC 4.2.207.0 to 6.0.199.0 (WiSM), and WCS 5.2.130.0 to 6.0.196.0. All my heatmaps that contain 1231G LAPs are solid "maroon" (-35 dBm) in color. If I remove the 1231 APs from the heatmap selection on the right hand side, my coexisting 1131 and 1142's display their heatmaps properly. My maps are all CAD format (dwg) converted to .png's using WCS. My goal is to migrate to 802.11n in small steps which our Cisco rep said we could do. Any ideas?

1 Reply 1

rob.drye
Level 1
Level 1

Unfortunately, this is a bug in 6.0.199.0.  The "fix" is to upgrade to 7.0.98.0 or 6.0.199.4.  As you figured out, it only affects 1230 series APs, and only on the 802.11b/g side.  Bug ID was

CSCti05687

Incorrect power unit was used on AIR-AP1231G-A-K9 and IR-AP1220-IOS-UPGRD.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: