1524 LAP with 2.4, 4.9 and 5.8 radios. The WLC configuration is setup to allow client access via the backhaul interface. There's a need to be able to access from 4.9 and 5.8 clients. 4.9 clients work fine as do the 2.4 clients. The 5.8 is used for Mesh (RAP/MAP) though a need has arisen to allow client access via the 5.8 radio. The WLC has been configured to allow client access through the mesh/backhaul wireless interface though it doesn't work.
Is client access through the 5.8 interface possible or would we have to install a second 5.8 interface?
Hi, My customer wants to Download a report of users with MAC addresses who logged in June 2020. He is using PRTG but that Server is not connected with WLC. What we need to do to achieve this goal? Thanks in advance. Regards,Waqas
[ The link to the discussion will be published on November 10th ]
This event is an opportunity to discuss the LTE market trends from a consumer perspective, highlighting the 4G LTE service from Cisco Enterprise BU. Furthermore, we will discuss the strateg...
Hi All,We have 9100 AP trying to join on 9800 WLC. When AP try to join controller it gives below error Sending Join request to 172.16.31.66 through port 5254Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Join(5)Discarding msg CAPWAP...
Hello, I hope somebody has a solution for the issue I am facing. I have 2 WAP150's, both with firmware 126.96.36.199, and I am not able to save a specific change. Under Wireless > Radio > Advanced Settings > Legacy Rate Sets I can unselect ra...