10-30-2019 03:11 PM - edited 07-05-2021 11:13 AM
I have 1815i access point, OS 8.5.140, I want to create 4 SSID mapped to different VLANs
- when access point boots, it gets to "(Cisco Controller)>" prompt, not ap# prompt
- attached files shows booting output, and GUI, they are not as described in config guides. so I can't follow the steps.
10-30-2019 05:21 PM
The 1815 can use Mobility express.
you need to configure it via the mobility express controller
10-30-2019 05:33 PM
it's the only access point I have right now. can it be configured with SSID's mapped to different VLAN's.
10-30-2019 05:39 PM
yes you map the WLANs to different VLANs and need port connecting to AP to be a trunk port allowing the VLANs
10-30-2019 05:56 PM
the access point boots with "(cisco controller)>" prompt, not ap#, also GUI is different that what is described in guides.
how can I configure it
10-31-2019 01:45 AM
Configure AP as master AP, it will act as WLC as well.
see the example here:
https://www.lookingpoint.com/blog/mobility-express
https://keepcalmandping.online/2019/03/18/cisco-mobility-express-experience/
After Setup, configure the port on switch side as: The following is a sample switch port configuration.
Interface GigabitEthernet1/0/37
description » Connected to Master AP «
switchport trunk native vlan 122
switchport trunk allowed vlan 10,20,122,123,124
switchport mode trunk
Regards
Dontf orget to rate helpful posts
11-01-2019 05:01 AM
I will try resetting the AP, and follow the advised tutorials, and post the updates.
thanks,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: