I have 1815i access point, OS 8.5.140, I want to create 4 SSID mapped to different VLANs
- when access point boots, it gets to "(Cisco Controller)>" prompt, not ap# prompt
- attached files shows booting output, and GUI, they are not as described in config guides. so I can't follow the steps.
The 1815 can use Mobility express.
you need to configure it via the mobility express controller
yes you map the WLANs to different VLANs and need port connecting to AP to be a trunk port allowing the VLANs
the access point boots with "(cisco controller)>" prompt, not ap#, also GUI is different that what is described in guides.
how can I configure it
Configure AP as master AP, it will act as WLC as well.
see the example here:
After Setup, configure the port on switch side as: The following is a sample switch port configuration.
description » Connected to Master AP «
switchport trunk native vlan 122
switchport trunk allowed vlan 10,20,122,123,124
switchport mode trunk
Dontf orget to rate helpful posts