Re: 5 GHz channel 144 (5710 GHz ~ 5730 GHz) selection on Cisco AP
Your AP models do not support that channel (frequency 5.720), even as B models. If you were using a 1572 or 4800 this would work as they are later models with support for that particular channel. You can see this in the datasheets where both models only support A Regulatory domain rates:
QuestionI have the following Air AP:Air-AP1562I-B-K9, 802.11ac outdoor access point There are three antenna cables that go from the inside cover to some soldered connections on a PCB. When removing the cover, two of the soldered antenna connections c...
QuestionHiWe have a guest access set up and was wondering what exactly are the sequence of events from connecting to SSID to being granted internet access, see below steps I'm unsure of are left blank1. connect o SSID through AP2. traffic hits Foreign WLC...
Model:C9120AXI-Q Install EWC on C9120 running with CAPWAP as shown in the attached log, but the installation fails.It looks like you're getting an error like out of storage space.Is there any good way?