05-31-2016 08:24 AM - edited 07-05-2021 05:09 AM
I am trying to use the USB0 and USB1 in a 5508 WLC. I have formatted my flash drive for FAT and FAT32 without success. I want to transfer some files over, is this possible using the USB ports in the front of the controller?
Solved! Go to Solution.
05-31-2016 08:47 AM
it was hw option included on the original chassis design, but it was never activated on the software side
(no feature implemented)
regards
05-31-2016 08:36 AM
hi
not supported
regards
05-31-2016 08:41 AM
Thanks for your reply. Is there any Cisco documentation on this? I have looked but very limited info. Also if not supported what are those USB ports used for?
05-31-2016 08:47 AM
it was hw option included on the original chassis design, but it was never activated on the software side
(no feature implemented)
regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide