I have just completed an 18AP install at my place of employment and we have run into a slight problem.
The Apple clients on our wireless LAN cannot discover printers through the bonjour protocol.
Am I correct in saying this would be related to either a unicast or multicast issue?
Can someone point me in the correct direction on how to begin configuring either unicast or multicast between the 5508's and other switching devices.
Currently I have the 2 5508's patched into a 3750 (which provides routing) and from that switch on, the other AP's connect from the network.
Enable Multicast Globally on the WLC..
WLC GUI >> Controller >> Multicast >> Enable Global Multicast >> Enable Snooping >> Let the timeout be in defaults (60 seconds)..
and follow the below link..
lemme know if this helps and please dont forget to rate hte usefull posts!!
i am having similar issues .. I enable snooping from 3 to 15 min... Now i am able to print or printer shows up for 15 min then it disappear again until I restart the printer again... This happen to two different printers
its a AIR-WLC2112-K9
Product version 126.96.36.199 boot loader: 188.8.131.52
Airprint may not be compatible with IGMP snooping -- I've seen cases where igmp snooping needs to be disabled for reliable service. I'm not sure if Airprint can be configured to participate in IGMP.
if i disable IGMP snooping then it doesn't even show up on the iphones or ipads.. its says printer cannot be found
if i restart the printer again its availble for 15 min or so then it disappers -
printer epson artisan 837